aMG USB Connect

Product Code:amg-usb-connect

Be the first to review this product

Availability: 8 in stock


Quick Overview

  • Based on FT231XS-R Full Speed (12 Mbits/sec) USB-UART Converter
  • Enable Automatic Compile and Download (flash programming) when working with Matlab & Simulink, Waijung Blockset, and STM32F0 Target
  • Enable Hardware-in-the-Loop Test
  • Stackable with FiO Glide and FiO Mote series
  • More background information

aMG USB Connect

More Views


Key Features

  • Single chip USB to asynchronous serial data transfer interface.
  • Entire USB protocol handled on the chip. No USB specific firmware programming required.
  • Fully integrated 2048 byte EEPROM for storing device descriptors and CBUS I/O configuration.
  • Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.
  • Data transfer rates from 300 baud to 3 Mbaud.
  • 512 byte receive buffer and 512 byte transmit buffer utilising buffer smoothing technology to allow for high data throughput.
  • FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
  • Configurable CBUS I/O pins.
  • Transmit and receive LED drive signals.
  • UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity
  • Synchronous and asynchronous bit bang interface options with RD# and WR# strobes.
  • Battery Charger Detection. May be used by mobile devices to detect the presence of a charger on the USB port to enable higher current / faster charging of batteries.
  • Device supplied pre-programmed with unique USB serial number.
  • Supports bus powered, self powered and high-power bus powered USB configurations.
  • Integrated +3.3V level converter for USB I/O.
  • True 3.3V CMOS drive output and TTL input.
    • (operates down to 1V8 with external pull ups and is also 5V tolerant)
  • Configurable I/O pin output drive strength.
  • Integrated power-on-reset circuit.
  • UART signal inversion option.
  • Internal 3.3V/1.8V LDO regulators
  • Low operating current of 8mA (typical) and USB suspend current of 125uA (typical) current.
  • Low USB bandwidth consumption.
  • UHCI/OHCI/EHCI host controller compatible.
  • USB 2.0 Full Speed compatible.
  • Extended operating temperature range: -40°C to 85°C
  • Available in compact Pb-free 20 Pin SSOP and QFN packages (both RoHS compliant).

Additional Information

Free Shipping Free Shipping

You may also be interested in the following product(s)



FiO Mote - ST

FiO Mote - ST

aMG PWS 3V3/5V v2

aMG PWS 3V3/5V v2

FiO Glide

FiO Glide

FiO Mote - ST Starter Pack

FiO Mote - ST Starter Pack

FiO Glide Starter Pack

FiO Glide Starter Pack


Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Write Your Own Review

You're reviewing: aMG USB Connect

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars
Pros Cons
Enter your Pros, separated by comma Enter your Cons, separated by comma