aMG USB Converter - N2

Features

1. Implement the FTDI Chip: FT2232H Dual High Speed USB to Multipurpose UART/FIFO IC
     • Single chip USB to dual serial / parallel ports with a variety of configurations.
     • Entire USB protocol handled on the chip.
     • No USB specific firmware programming required USB 2.0 High Speed (480Mbits/Second) and Full Speed (12Mbits/Seconds) compatible.
     • Dual Multi-Protocol Synchronous Serial Engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI or bit-bang) design.
     • Dual independent UART or FIFO or MPSSE ports. Independent Baud rate generators
     • Fast Opto-Isolated serial interface option.
     • Free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases. Adjustable receive buffer timeout
     • Independent Baud rate generators
     • RS232/RS422/RS485 UART Transfer Data Rate up to 12Mbaud. (RS232 Data Rate limited by external level shifter)
     • UART Interface supports 7/8 bit data, 1/2 stop bits, and Odd/Even/Mark/Space/No Parity
     • +3.3V I/O interfacing (+5V Tolerant)
2. Extended -40°C to 85°C industrial operating temperature range
3. MatlabTM/Simulink block support Fast Serial Blocks enable up to 1kHz closed-loop Simulink HIL Simulation
4. ROHS Compliant

Applications

• Generic 2 Ports USB - Serial/SPI/I2C Converter
• Hardware in the Loop Simulation and Test